588313jpg.jpg



Few companies know more about mouthpiece manufacture, design and physics than the Schilke Company. They make a complete line of excellent trumpet mouthpieces that work with any instrument but especially compliment their fine line of outstanding trumpets. 
Schilke Silver Trumpet Mouthpiece Series
When choosing a Schilke mouthpiece:
• The first digit in the model number is the cup diameter
• The first following letter is the cup volume
• The second number represents the rim contour
• The second letter refers to the backbore




CUP DIAMETER (First number in label)
Most trumpet and cornet mouthpieces have a cap diameter that falls between .600" and . 725". Nos. 1 to 25 in the Schilke system represent sections of .005" each between these two measurements. Cup diameters for mouthpieces other than trumpet and cornet are relative to each other with the smallest numbers representing the smallest diameters

CUP VOLUME (First letter in label)
In general the deep cup mouthpieces produce the darkest sounds. In reverse the shallow cup mouthpieces produce the brightest sounds and also aid in the production of the high register. The Schilke "C" cup is a comprise which offers both full tone and ease of production. In switching from one instrument to another i.e., Bb trumpet to D trumpet, it is usually good to use a mouth piece that is .025" shallower in the cup volume with all other dimensions remaining the same. The higher the instrument is, the shallower the cup should be. A player who needs primarily a good range without sacrificing much tone can consider a hollow mouthpiece with a widened 2nd cup. The shallow 1st cup affords support in the top register and the widened 2nd cup allows a full tone.

RIM CONTOUR (Second number in label)
The #3 Schilke rim has the feel that most players prefer in a rim. It has flat enough contour to distribute the slight pressure needed to provide an air seal but is rounded slightly to offer increased flexibility. Generally a rounder rim will allow greater flexibility but sometimes tires the player sooner. A flat rim often feels the most comfortable but tends to hold the lips in a fixed position, thereby reducing flexibility.

BACKBORE (Last letter in label)
Schilke mouthpieces all come with standard backbores (letter C) which permit the maximum in tone and range. Other backbores are available (Letters a, b, d, e) which might suit particular needs of players. The tighter backbores tend to make the sound more brilliant while the larger backbores tend to make the sound more mellow. Occasionally a change in backbores will cause an alteration in intonation which often can correct faulty intonation on an instrument.

THE FIT OF THE MOUTHPIECE
The shank of every brass mouthpiece when in the instrument should touch the end of the mouthpipe to insure an even taper from the backbore of the mouthpiece to the inside of the mouthpipe. Dirt inside the throat or backbore of a mouthpiece can greatly alter the intonation of the instrument on which it is used. Mouthpieces can only be kept clean with a mouthpiece brush used every week